Home > Ericsson F3507g > Ericsson F3507g Linux Driver

Ericsson F3507g Linux Driver

Contents

It doesn't work at all in Vista, which no longer detects it as a device - presumably this must be down to the BIOS update. the echo line should be: echo enable > /proc/acpi/ibm/wan Mathieu Trudel-Lapierre (cyphermox) wrote on 2011-04-14: #52 Judging from the existence of bug 756553; I'd venture to say that this dongle works One thing I noted is that I found no way to enter the PIN, which the SIM module requires. As of kernel 2.6.33 it is named wwan0 rather than usb0. have a peek at these guys

Is the WWAN card ON? Vodafone UK) MB_SIGNALThe current signal strength represented using characters from the 'PizzaDude Bullet' font (downloadable from dafont.com) MB_TYPEThe current network access type (GPRS, 3G, 3G+, NONE) These files are only updated Can you post the error returned when you run dell5530_mon.py? I intend to bring this functionality within dell5530_mon.py but haven't done so yet.

Ericsson F5521gw Linux

NAND-flashmemory: - special features: integrated GPS receiver integrated in: Dell Inspirion Mini 9 (a.k.a. If all those versions don't make a difference, I would think that this could also be a bios bug or something - trying to upgrade that might be worth it. Specific versions of this card may come pre-configured for a certain carrier (AT&T) Features Chipset: Ericsson F3507g USB ID: 0bdb:1900 USB ID: 0bdb:1902 WCDMA 2100/1900/850MHz GSM/GPRS/EDGE 850/900/1800/1900MHz GPS Download up to The other way is to use CDC Ethernet interface.

  1. The kernel rfkill subsystem orders thinkpad-acpi to kill the radio (check /sys/class/rfkill/*), which it can do at any time, for any reason; >No rfkill for wwan card (used to be there)
  2. I hope this helps you a bit Mats Thinkpad T400s, X61s, X41, 600 0 Kudos Reply billbolton Community Moderator Posts: 1,948 Registered: ‎12-02-2007 Location: Sydney, Australia - Best Address on
  3. the card provides three CDC ACM interfaces (CONFIG_USB_ACM=m), two CDC WDM interfaces (CONFIG_USB_WDM=m) and one CDC Ethernet interface (CONFIG_USB_NET_CDCETHER=m), and identifies them as for n in `ls /sys/class/*/*{ACM,wdm,usb0}*/device/interface`;do echo $(echo $n|awk
  4. In such a situation one of the following methods could solve the problem: Use the killswitch to reset the card.
  5. Thanks for your help so far - it's much appreciated!
  6. Hope this helps somebody with a locale which uses umlaute (äüö) ;-)Keep up the good work!Alex 15/3/10 09:34 Barry said...
  7. Alain Rossmann (alain-the-roffmans) wrote on 2009-07-08: #36 Experiencing same problem on Lenovo X200 with embedded Ericsson F3507g card.
  8. Note some operators have different APNs and credential depending on whether you are on contract or pay as you go so it might be worth checking this out too. 11/2/10 10:32
  9. i just tried to apply it to the 2.6.27 source and got the following: Code: patching file drivers/usb/serial/option.c patch: **** malformed patch at line 6: *tty, struct usb_serial_port *po if anyone's
  10. Love fighting with Linux?

Note that I'd very much like to know if it works in Maverick too, and if you're still having issues in Natty, please don't hesitate to open a separate bug so Chris Roberto Tyley (roberto-tyley) wrote on 2009-04-28: #32 LenovoX200.FullJauntyReinstall.WORKING-BEFORE-SUSPEND.20090428.tar.gz Edit (94.5 KiB, application/x-tar) Upgrading to BIOS v2.06 actually did change behaviour - it stopped the Ericsson F3507G card working on either It turns the card completely off, and it will no longer accept any AT-commands before the hard reset. Lenovo Mobile Broadband Activation Windows 10 GPRS + UMTS Radio on at+cfun=1 GPRS + UMTS Radio off at+cfun=4 GPRS (UMTS Radio off) at+cfun=5 UMTS (GPRS Radio off) at+cfun=6 CDC Ethernet Setup The Kernel generates a new ethernet

Instructions All information about how to get mobile broadband modules working is available on the MBM wiki. It retries as often as necessary until the WWAN connection is really established. Now you can read the NMEA stream by saying cat /dev/ttyACM2 or better yet, start gpsd interface on /dev/ttyACM2. I figured that the AT&T  provided software was just setting up a dial-up connection with specific settings.

Scripting everything Install the packages apt-get install sysfsutils gpsd wvdial In order to save the power, let us use sysfsutils to completely power off the WWAN card on boot. Starting PPP immediately.--> Starting pppd at Wed Feb 10 23:59:44 2010--> Pid of pppd: 6221--> Using interface ppp0--> pppd: x�[06][08] �[06][08]��[06][08]--> pppd: x�[06][08] �[06][08]��[06][08]--> pppd: x�[06][08] �[06][08]��[06][08]--> pppd: x�[06][08] �[06][08]��[06][08]--> pppd: Henrique de Moraes Holschuh (hmh) wrote on 2009-07-09: #38 The thinkpad-acpi upstream maintainer here. And now the next quest: How to use the GSM part of the module ?

Ericsson F3507g Driver

M B M Mobile broadband modules About This project is dedicated to providing GNU/Linux software for the Ericsson Mobile Broadband devices f3507g, f3607gw, f3307, c3607w and f5521gw. Clicking Here Henrique de Moraes Holschuh (hmh) wrote on 2009-07-09: #39 Ah, I forgot the *obvious*: Make sure EHCI-HCD *and* UHCI-HCD are running properly, or the USB bus won't work, and obviously the Ericsson F5521gw Linux I have a Dell D420 on Windoze for which the f3507g isn't supported - the manager won't install. Ericsson F3507g Specifications Join Date Jun 2006 Beans 50 Re: Setup and Configuration of Ericsson F3507g WWAN Card @guhl: fantastic!

sudo apt-get install ppp wvdial sysfsutils sudo nano /etc/sysfs.conf Paste the following: block/sda/queue/scheduler = noop
devices/platform/thinkpad_acpi/bluetooth_enable = 0
devices/platform/thinkpad_acpi/wwan_enable = 0
class/leds/tpacpi::power/brightness = 0 sudo nano /etc/pm/sleep.d/sysfsutils Paste the following: #!/bin/bash
More about the author Which was unfortunate, as that has occasionally left me at the mercy of brutally inefficient and expensive hotel wireless. NOTHING can reenable the device until you disable the radio-kill switch. In fact, executing: ls -R /sys/class/ | grep -i acm returns zero results. Ericsson F3507g Driver Windows 10

Hi ! To disconnect, send AT*ENAP=0 to /dev/ttyACM1. So I am not sure what caused my issue. http://wpeasyposttypes.com/ericsson-f3507g/ericsson-f3507g-wmc-drivers.php How to set up is descripted very easy, but I haven't got this running yet.I'm using a Lenovo T400 with OpenSuse 11.1 and kernel 2.6.27.42-0.1-pae.The script's from Barry I have implemented

Kotsbak (mariusko) wrote on 2012-10-17: #54 Andrew: this is the wrong place to discuss unrelated problems. at+cpin? Without this the modem is visible to the OS and i can run wvdial, but it just disconnects after trying to connect.So i added this to the wvdial.conf as an init

I don't know if NetworkManager is necessarily at fault here - is there a lower subsystem this issue would be better addressed at?

Using the card as a GPS receiver Once the card is turned on, we can use it to get GPS info via NMEA protocol. Adv Reply October 16th, 2008 #10 guhl View Profile View Forum Posts Private Message First Cup of Ubuntu Join Date Oct 2008 Beans 4 Re: [SOLVED] Setup and Configuration of Adv Reply October 9th, 2008 #7 sog View Profile View Forum Posts Private Message Just Give Me the Beans! I have not been able to make the card work by hibernating/resuming.

Why? If even Linux can't find the device it's definitely broken and needs to be replaced. I've seen similar posts in various discussion lists but no working solution was ever offered. 10 out of 11found this valuable. http://wpeasyposttypes.com/ericsson-f3507g/ericsson-f3507g-wmc-driver.php The F3507g card (in a ThinkPad T400s) works out of the box on Fedora 11.

maybe remove the module and check whether you still see the cdc_acm messages in dmesg. Once I added it PPP received an IP address. Please open a new bug report by typing "ubuntu-bug modemmanager" in a terminal. Buy Preinstalled!